BTS7960 Module
The high-power motor controller BTS7960 Module allows you to manage a motor with a maximum current consumption of 43 A. The board is tiny in size and comes with a heat sink and screw connections. Short-circuit, overload, and overheating protection is included in H-bridge BTS7960 Module systems. Just need four lines from MCU to the driver module (GND. 5V. PWM1. PWM2). Isolation chip 5V power supply (can share with MCU 5V) can also use the onboard 5V supply.
In addition, the module can be controlled at the Arduino, Raspberry Pi, and STM levels. The operating voltage range is 5.5 to 27 V. Overvoltage, short circuit, and overheating protection are also included in the module. It is controlled by PWM with a frequency range of up to 25 kHz.
Key Product Features:
- H-bridge BTS7960 Module constructed from two Infinityon BTS7960 systems
- Allows you to change the direction of operation of a DC motor.
- Double BTS7960 H bridge driver with high current (43 A).
- 5V isolation with MCU and efficient MCU protection
- On-board 5V power indicator.
- The voltage indication of the motor driver output end can be soldered to the heat sink.
- It has either a current measurement output or an error warning output.
- Power systems are separated from the control signal by a built-in buffer.
Applications:
- Current diagnostic
- Slope adjustment
- Dead Time generation
- Over-temperature, over-voltage, under-voltage, over-current protection
- Short circuit protection.
Specifications:
- RPWM: Right Turn PWM
- LPWM: Left Turn PWM
- R_EN: Right Turn Enable (High Active)
- L_EN: Left Turn Enable (High Active)
- R_IS: Right Turn Current Warning (May Leave Floating)
- L_IS: Left Turn Current Warning (May Leave Floating)
- VCC: (5V)
- GND
- Size: 4 x 5 x 1.2cm
Connections:
Method 1:
- VCC: 5V from Microcontroller(MCU)
- GND: GND from Microcontroller(MCU)
- L_PWM: PWM or 5V from Microcontroller(MCU) for CCW(CW) Turns
- R_PWM: PWM or 5V from Microcontroller(MCU) for CW(CCW) Turns
- R_EN and L_EN: 5V from Microcontroller(MCU)
Method 2:
- VCC: 5V from Microcontroller(MCU)
- GND: GND from Microcontroller(MCU)
- L_PWM: 5V from Microcontroller(MCU) for CCW(CW) Turns
- R_PWM: 5V from Microcontroller(MCU) for CW(CCW) Turns
- R_EN and L_EN: PWM from Microcontroller(MCU)
Package Contains:
- 1pc